ALL KITS ON SALE! Save Hundreds! Large Project? Request a Quote.
  • VERTICAL PRO - 100% EPOXY BLOCK FILLER

VERTICAL PRO - 100% EPOXY BLOCK FILLER

VERTICAL PRO is a two component 100% solids epoxy colored coating designed for applications to vertical surfaces at a high build while resisting sags or slump.
 Recommended for cement or concrete block applications up to 15 mils thick without ru ...
  • $0.00

Customise your product

Available Options

VERTICAL PRO is a two component 100% solids epoxy colored coating designed for applications to vertical surfaces at a high build while resisting sags or slump.


Recommended for cement or concrete block applications up to 15 mils thick without runs at 70F. Good resistance from sags or runs from 10-20 mils at 70F.

COVERAGE PER GALLON: 80-160 square feet per gallon @ 10-20 mils

RECOMMENDED FOR: Recommended for priming or coating concrete, wood or masonry that’s vertical. 

CURE SCHEDULE: 50-90 degrees F with relative humidity below 90% 

pot life – 1 gallon volume ………………...…....45-90 minutes @ 70° F
tack free (dry to touch)…………..……………..…10-14 hours @ 70° F
recoat or topcoat.....…………….……………….....14-16 hours @ 70°F
light (industrial use)……………………...…..……16-24 hours @ 70°F
full cure (heavy traffic)... ……………...………...…....2-7 days @ 70°F

PRODUCT APPLICATION: The mixed material can be applied by brush, roller, or spray. Maintain temperatures and relative humidity within the recommended ranges during the application and curing process. Apply the material between the recommended thicknesses to avoid sags and runs.

PRIMER: Recommended HDWB-V 

TOPCOAT: None normally needed (for increased chemical resistance and increased UV stability use an aliphatic urethane topcoat)


LIMITATIONS:
Color or gloss may be affected by environmental conditions such as high humidity, low temperatures, chemicals or certain types of lighting. *Colors may vary from batch to batch. Therefore, use only product from the same batch for an entire job. Apply a suitable primer before using this product when necessary. This product is not UV color stable but has good resistance to color change for an epoxy. A topcoat is optional dependent on the environment. Light or bright colors may require a suitable primer or topcoat to achieve a satisfactory hide. Test sag resistance at job sight as environmental conditions, including type of substrate, humidity or temperature may cause variable results. Substrate temperature must be 5°F above dew point. For best results, apply with a 3/8” nap roller.. All new concrete must be cured for at least 30 days prior to application. See reverse side for application instructions. Physical properties are typical values and not specifications.

Tags: Recommended for cement or concrete block applications up to 15 mils thick without runs at 70F. Good resistance from sags or runs from 10-20 mils at 70F.